Redwood Biotech's on-site drug screening devices are easy to
use! Please follow the simple instructions below.
Remove device from foil pouch
Pull plastic cup from
device
Dip
revealed sample pads into urine
sample for a minimum of 15-30
seconds until urine is seen wicking
into the reading zone. Make sure
each pad is dipped into the specimen
to the level of the wavy lines
without touching the plastic card to
the urine.
Remove the device from the
urine and replace the
plastic cap.
Read test results at
5 minutes. (Do not
interpret results
after 4 hours as
false results may
occur. Note: Any
line at all in the
test zone is to be
interpreted as
negative.)
Negative
Color line
appears
in Test (T)
Zone
Positive
No Color
line appears
in Test (T)
Zone
Invalid
Color line
must appear
in Control
(C) Zone for
test to be
valid
Sending
Presumptive
Positive
Specimens
to
SOS
for
GC/MS
Confirmation
Perform the on-site test according to the instructions provided above.
Complete the Preliminary Results Form, indicating the positive and negative test results. Make sure the donor signs the form.
Secure the positive specimen in the bottle. To prevent leakage, make sure the lid is threaded properly and tightly fastened.
Place the security seal over the top of the bottle.
Fill out the Specimen ID/Chain of Custody Label and indicate the positive drug(s) on the line marked "GC/MS Confirm:___________".
Place the label on the bottle.
Instruct the donor to initial the security seal.
Seal the bottle in a plastic baggie with the absorbent material.
Make a copy of the Preliminary Results Form and place it in the DHL/Airborne bag (five or more specimens) or the mailer box (fewer than five specimens) with the specimen.
Send to SOS for GC/MS confirmation.
*Please do
not send
negative
specimens to
SOS for
confirmation.
Negative
specimens
will not be
confirmed.
To learn
more about
the
Panel/Dip
Device call
today!
